Any tricks to pulling shafts from the FT-3? - Shot Talk

**Clugnut** · iTrader: (3) #1 (**permalink**) 10-19-2007, 11:25 AM

Is there anything special to pulling a Callaway shaft? Is there anything special I need to do because of the adapter? Thanks

SilverUberXeno · iTrader: (2) #2 (**permalink**) 10-19-2007, 11:48 PM

My only advice is to NOT take it to have it done at Dick's Sporting Goods.

Callaway is trying to fix that mess as we speak

Indacup had some advice on it, and Lyle did too. Wait for one of them to chime in.

**Clugnut** · iTrader: (3) #3 (**permalink**) 10-20-2007, 08:47 AM

I figured it out! Cut the b-i-itch off and drill it. That NVS-R played too soft anyway.

Rockford35 · iTrader: (5) #4 (**permalink**) 10-20-2007, 05:09 PM

This is what I did. It takes some patience, but when you're done, you have an un-effed up FT-3, which is the goal, no?

Good luck,

R35

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Iron Shafts?	Sandpiper3	Equipment talk	17	10-20-2007 06:02 AM
What are the Best STEEL IRON SHAFTS!!??	WildCatGolfer17	Equipment talk	9	09-27-2007 09:23 PM
Shaft guide and premises...	Coagulator	Equipment talk	7	07-20-2007 03:27 PM
TT Black Gold Shafts	bames	Equipment talk	24	03-20-2007 05:28 PM
New shafts question	Eracer	Equipment talk	13	07-27-2006 02:17 PM