Clubmakers--Re-shafting question - Shot Talk

RC52 · iTrader: (0) #1 (**permalink**) 07-16-2008, 01:24 AM

Let say i have 43.5" shaft out of a driver that has been tip prepped 1 1/8" and I want to put it in a Cleveland Launcher 3 wood at a installed length of 43". Am i going to run into any issues?

**King Par** · iTrader: (0) #2 (**permalink**) 07-16-2008, 02:01 AM

You'll most likely have to tip it to 3 wood specs and then butt trim to length.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tip question for clubmakers...	BigJim13	Equipment talk	1	06-02-2008 01:12 PM
Question about shaft length for the clubmakers...	Johnny Par	Equipment talk	2	05-20-2008 07:28 AM
Question about the Tour Tempo "Y" & "L" drills	$2 Nassau	Shot Talk	3	07-09-2007 10:53 AM
Question for Lyle or the other clubmakers here	MGP	Equipment talk	11	05-21-2007 03:16 PM
Dumb Question about scuff's on the face.....	Fuzzifus	Equipment talk	5	06-13-2005 11:00 AM