Swapping Shafts in my iron set

[import49erz]

I currently have two sets of irons. Titleist 704.CB with the NS PRO 970 shaft. Titleist website says its a .355 taper tip. My other set is a Mizuno MP30 with Dynamic Gold S300 .355 shaft.

I was just wondering if I could swap the shats between the two sets of irons. I am playing the MP30s and like the NS Pro shaft cause its lighter and I get a good feel with it. I just like the feel of the MP30 head.

Thanks.

[RCI]

I can't answer the question, but I just had my DG S300s swapped for DG S300 lites with sensicore added -- to both close the weight gap and hopefully provide a little vibrational dampening. It did take a while for True Temper to make this configuration. Overall the weight is a little less, and I really like the way the new shafts feel.

Lighter shafts are not always a good thing for irons, but I am surprised I like my new ones so much. I hope you can try it and it works out well for you. I don't know the insertion/hosel depths for your irons but if it's the same, go for it. Surely someone here who does this can answer better than I have. I just know I changed and so far am happy.

[MIKE1218]

I currently have two sets of irons. Titleist 704.CB with the NS PRO 970 shaft. Titleist website says its a .355 taper tip. My other set is a Mizuno MP30 with Dynamic Gold S300 .355 shaft.

I was just wondering if I could swap the shats between the two sets of irons. I am playing the MP30s and like the NS Pro shaft cause its lighter and I get a good feel with it. I just like the feel of the MP30 head.

Thanks.

Same tip size. Swap em, and good choice with the mp30's.

[import49erz]

Thanks for the input, so the taper tip wouldnt matter? I heard some say it would so I wasnt sure.

[LyleG]

The only way you could run into a problem here is if the bottom bore to ground measurement is different on the 2 head styles. You may end up with clubs slightly shorter or longer than the ones you currently have.

[MIKE1218]

Thanks for the input, so the taper tip wouldnt matter? I heard some say it would so I wasnt sure.

Not sure what you mean. Both of the shafts are .355 taper tip.

[packwood]

The shafts in the titleist may sit deeper in the hosel than the Mizuno or visa/versa. you might have to adjust lengths. I have done this kind of swapping. I prefer Hogan shafts for wedges. Ping/hogan shafts should also work.

[import49erz]

thanks, I think I will go for the switch than, just have to make sure I get the correct measurement in as far as lengths go. Now I have to learn how to pull the shafts and do it myself, as I got some prices on swapping the shafts between the irons and they are going to cost me an arm and a leg.

[FATC1TY]

Look for a used or cheap shaft puller and learn how to do it yourself.

I'm looking to do the same with my irons sets.

I have S300's in my CB's, and Rifle 6.0 in my MB's. I also have a set of PX 5.5's I'm tempted to toss in one of the sets, probably the MB's.


If it's alot to get your irons re-shafted(and I don't know whats considered reasonable), then do it yourself if you can.