Getting wedges stamped with initals

[huggystyle]

Hi


Does anyone know of any service in the UK where you can get your wedges stamped. I'm going to treat myself to some new vokeys and I wondered if anyone knew.


Thanks

[MIKE1218]

You could try doing it yourself. A guy I know has something similar to this and he stamped some of his own clubs.

36 Number Letter Punches Jewelers Metal Stamp Tools 6mm - eBay (item 360066133023 end time Jul-06-08 16:00:52 PDT)

[Slingblade61]

I know that Cleveland does laser etching of logo's and names.

Get CG12 instead.

Or you can just get this done... http://www.vokey.com/wedgeworks/cust...ewOptions.aspx

[JArmour]

Originally Posted by MIKE1218

You could try doing it yourself. A guy I know has something similar to this and he stamped some of his own clubs.

36 Number Letter Punches Jewelers Metal Stamp Tools 6mm - eBay (item 360066133023 end time Jul-06-08 16:00:52 PDT)

How do these work out? Do his clubs look legit or can you tell it's a little shady?

[Wi-Golfer]

I have a set of those out in the garage, going to go out right now & attempt to initial an old club. Will report back.

[MIKE1218]

Originally Posted by JArmour

How do these work out? Do his clubs look legit or can you tell it's a little shady?

They worked out just fine, but I'm not sure how to explain it. They look different from what you might get from the the SC Custom Shop, a little rougher I guess. Wait for Wi-Golfer to report his findings.

[Wi-Golfer]

They worked ok, especially considering I rushed it. On the bottom of the club I only hit the G 1 time while the others I stamped twice. On the Hosel I hit the G once also while the others I rotated downward a bit on the 2nd hit so the entire letter would show up. If someone wanted to take their time, this could work very easily.

[zaphod]

That looks pretty cool I've got a set of stamps too. Will give it a try too

[ezra76]

Not too bad looking. Just be careful not to fly the green, after all, that's an 8iron, not the gap wedge.

[JArmour]

That looks good. I'm sure you could make the "dancing" style if you wanted to.

Did you clamp the club in a vise and just hammer away at it?

[Wi-Golfer]

For the sole of the club I opened the vise up & just rested it on top, sort of like using an anvil. For the hosel just laid it on the work bench. Like I said if someone took longer than the 1 minute I spent just seeing if it work, they could turn out a nice job.


EZ, I will get bigger punches & label all the clubs as "GAP" wedges Tee off on a 180 yd par 3, hmm think I will use the gap wedge.

[JArmour]

Sweet, thanks for trying it out Wi.

Im going to try the wedges out first I think.