Ok question will be about tourqe specs.
1. Hitting an R9 pretty well not many slices.
Shaft Accra S2, M4 65, Stiff. About . 5 inch short.
tourqe shown as 2.5, low mid.
2. took cobra speed zone topga hit several shafts. None that I can afford.
Seemingly best one was Tensi AV Blue 65, stiff. Tourqe 3.9
hit left a lot. I don’t trust launch monitors too much.
when I hit stock cobra yes I did hit some fat slices.
off the half dozen unaffordable shafts, the tensi was mostly left. They all were which is suspicious.
But ball speed was more consistent, 127 138 min max hit it a good dozen times.
so ok that was long winded.
question … wouldn’t a low tourqe be harder to hit straight if I’m at the lower end of swing speed? ALL of my R drivers slice big time.
I wonder if I can get results from 50 to 80 dolla shafts
1. Hitting an R9 pretty well not many slices.
Shaft Accra S2, M4 65, Stiff. About . 5 inch short.
tourqe shown as 2.5, low mid.
2. took cobra speed zone topga hit several shafts. None that I can afford.
Seemingly best one was Tensi AV Blue 65, stiff. Tourqe 3.9
hit left a lot. I don’t trust launch monitors too much.
when I hit stock cobra yes I did hit some fat slices.
off the half dozen unaffordable shafts, the tensi was mostly left. They all were which is suspicious.
But ball speed was more consistent, 127 138 min max hit it a good dozen times.
so ok that was long winded.
question … wouldn’t a low tourqe be harder to hit straight if I’m at the lower end of swing speed? ALL of my R drivers slice big time.
I wonder if I can get results from 50 to 80 dolla shafts