FS: Proforce V2 76g X-Stiff Shaft

[Burg]

Flex: X
Wt: 76g
Torque: 2.2
Butt: 282
Mid: 7.7
Tip: 30
Tip Parallel: 4.0"
Tip: .335"
Length: 44.5" (if used as bore-through)

Shaft is bore-through and was professionally pulled from my 905R. Very good condition. I'm selling b/c I like the Stiff version better. Asking $50 + shipping.

I have pictures that I can email. I'll post them if I can figure out how.

PM me or email to: [email protected]

 

[Burg]

Here are some pictures.

 

[warbirdlover]

DAMN!! 1/2" too short. Was gonna buy this exact shaft form Golfsmith new for $70... and it's going in my 905R.

 

[Burg]

What's a half-inch among friends?

 

[Sandpiper3]

WBL, just put a half inch extention in it, it wont change flex or kick points at all. Just make it 1/2" longer.

BTW you dont need your driver at 45 anyway, I have mine at 44.25 and i can outdrive you and hit more fairways

 

[Dewey_1011]

I guess this won't work in my superquad will it? If it will I might just take that off your hands.

 

[Burg]

It will work in your SuperQuad but you may have to shave the shaft by .5 inches or so if the TM isn't bore-through. I'm not a clubmaker, but I think that I'm right on this.

 

[ezra76]

It would be a mess in the Superquad. Like he said you'll first have to level off the tip. Now it will be a little stiffer as well. Then it needs a shim to fit into the .350 hosel and lastly you'll have a bare prepped shaft area sticking out from the top of the ferrule. TM only has a 1.5" insertion depth, that's prepped 3 1/2" for a Titty installion.

This would make an awesome shaft for a Titleist 3W IMO. Untipped it will soften that X up a bit and make a 3W a high precision rifle.