GD Pershing VS UST Proforce

[abnrgn_71]

I am undecided on which shaft to match my Hi-bore 10.5* driver. My driver SS is about 90-95. More of a hitter. I have a GD Pershing 45 gm (R) and a UST Proforce V2 (R) about 52 gm
Anyone care to give comparison between the two shafts?

Thanks

Ron

 

[twofast2s]

i used to have a hibore 9.5* w/ 76g proforce V2 stiff shaft. very forgiving setup.
since then, i'm a fan of V2 shafts. there are other shafts out there which are better, but i like to stick w/ what worked for me. however, i heard 76g shaft and 66g shaft were totally different shaft.

i can't tell you much about the pershing though.

 

[Eracer]

I have the 67g Proforce V2. Low launch for my 90-95mph swingspeed. I paired it with a 12º head, and it looks like it's going to be a really nice combo. I'm not a fan of ultralite driver shafts, 65g is about as light as I like.

Can't comment on the Pershing either, ecept to say that I've tried a few GD shafts, and haven't liked any of them.

 

[abnrgn_71]

Thanks for your response. As I am Asian and medium built, I find it easier to use lightweight shafts, esp. the Japanes specs.

Ron

 

[twofast2s]

Thanks for your response. As I am Asian and medium built, I find it easier to use lightweight shafts, esp. the Japanes specs.

Ron

i'm also an asian and medium built... i use heavier shafts because i get better transition, not because i'm strong.