reshaft of a bore thru?

[BigJim13]

How hard is this to do? I have a 905R, like it well enough with the Aldila NV but am thinking of picking up a FW to go with it. Was looking at the 906F4 but it has a UST V2 81g shaft in it. I may or may not like the shaft so how hard is it to reshaft a bore thru head?

 

[BStone]

Bore through heads aren't too bad if you have the right equipment to pull the shaft, especially if you want to save the shaft that is in there. I just drill out the plug in the bottom, heat a drill bit and stick it into the bottom of the shaft, apply heat to the hosel and pull the head. I have a 99 percent success rate of saving the shaft that is in the head originally.

 

[LyleG]

The problem with the Titleists is the aluminum insert in the borethorough. It can be very easily damaged during a pull and would need to be replaced.