- Staff
- #1
- Joined
- Aug 13, 2006
- Messages
- 11,840
- Reaction score
- 3,154
- Points
- 363
How difficult is it to reshaft a bore thru clubhead? Does anybody know a link where I can see it done or have instructions on it?
For instance, looking at a 905R and thinking about pulling the shaft. I know there is a bore plug, do those get destroyed when heating and pulling?
I think I also saw that the tip needs to be cut on an angle? Is that correct and what kind of angle?
I would assume that for most shafts I should leave them untipped, is that correct as well?
Thanks guys!
For instance, looking at a 905R and thinking about pulling the shaft. I know there is a bore plug, do those get destroyed when heating and pulling?
I think I also saw that the tip needs to be cut on an angle? Is that correct and what kind of angle?
I would assume that for most shafts I should leave them untipped, is that correct as well?
Thanks guys!